Go To Duro Dyne Home Page

Back To Dyna-Tite Menu

Dyna-Tite Logo

STANDARD ASSEMBLY AND ADJUSTMENTS IN 4 EASY STEPS

STEP 1
Pull the release pin back and thread the wire rope into one locking channel
in the cable lock.

STEP 2
Pass the wire rope "tail" through (or around) the anchor point
(Eyehook, Beam, or Purlin).

STEP 3
Pull the release pin back and push the wire rope tail into the second locking
channel in the cable lock.

STEP 4
Prior to the load being applied, the wire rope can be adjusted in either direction.


ADJUSTING THE CABLE LOCK
With the load off the wire rope and the Cable Lock, push the release pin in the direction of the arrow on the Cable Lock.  This will release the locking pawl and allow the wire rope to be moved freely in either direction. (After a load has been applied it may be necessary to pull the cable slightly to disengage the teeth of the pawl).  Be sure the load is fully supported before attempting an adjustment.


HELPFUL HINT
To facilitate height adjustment, install the object low and adjust it upwards to the desired level.

Back to Top