Go To Duro Dyne Home Page

Back to 
Hardware Menu

VANE RAIL

Duro Dyne Vane Rail, made up of 24 gauge galvanized steel, is precision-stamped and slotted assuring uniform spacing of vanes and the fastest, easiest, most economical construction of vane assemblies. Duro Dyne Vane Rail is specially embossed adding strength and sturdiness to the finished section, eliminating rattling. Vane Rail can be used to make qualitiy turning vanes for any size elbow including change of size elbows. Air travelling throughout a duct is slowed up when it reaches a right turn angle. This "slow-up" is detrimental to the 

Vane Rail

efficiency of the duct system  therefore air turning vane assemblies are used to guide air evenly around such turns.  With today's high labor costs, it is expensive for shops to produce their own air turning assemblies.  That is why Duro Dyne Vane Rail is a major contribution to sheet metal shops that require efficient, yet inexpensive air turning assemblies. With Duro Dyne Vane Rail, which is a pre-fab side rail, layout time is eliminated. Vanes can be sheared from scrap metal without tab cutting, and quickly assembled to rails with only one blow of a ball peen hammer.


Specifications and Ordering

Vane Rail Specifications
Item # Code Description
4002 VR-2 Vane Rail 100 ft Continuous Coils
4003 JVR-2 Junior Vane Rail - Two 100 ft Continuous Coils
(Easily Dispensed Together or Singularly)
4007 VR-2-SS Stainless Vane Rail 100 ft Continuous Coils
4008 VR-2-AL Aluminum Vane Rail 100 ft Continuous Coils

Fabricating Air Turning Vanes

Forming Vanes

Securing Vanes

Gripping Action for Vane Rail

Shear and form vanes as indicated. Position vanes
in Vane Rail slot. Slots force vanes to take
correct curve.

Secure the protruding
vane with ball peen          hammer

Extra deep depression in Vane Rail allow for
superior gripping action. Vane assembly is then fastened in elbow.


Back to Top