Durodyne
 

 

 

 

Discontinued Pinspotters

MF-12

Duro Dyne’s MF has been the standard for entry level “through insulation” welders for over 30 years. Proven performance and high reliability have made the MF a “Must Have” for any sheet metal shop which does occasional insulating.

Duro Dyne now introduces the MF-12, building on that history, and creating a new pinspotter with greater power and versatility. Special design welding transformers allow the MF-12 to deliver more power, precisely timed to the welding tip. The new MF-12 will weld pins from ½ inch to 2 inches long on steel from 26 to 20 gauge. Proven solid-state weld control circuitry guarantees years of reliable, troublefree service in your shop.

Image 2 MF-12 Manual >

 

 

 

 

 

 

 

CDMF110 COMPACT PINSPOTTER

Duro Dyne introduced the CDMF110, a new compact pinspotter with greater power and versatility that is powered by a single 110 volt power source! Special design welding capacitors allow the CDMF110 to deliver more power, precisely timed to the welding tip. The new CDMF110 will weld pins from 1/2 inch up to 4 inches long on steel from 26 to 16 gauge. It is designed for use with both internal duct liner as well as external foil faced duct wrap. Proven solid-state weld control circuitry guarantees years of reliable, trouble-free service in your shop.

Image 2 CDMF110 Lit Sheet >
CDMF110 Owner's Manual >

 

 

 

 

 

 

 

FG MACH I & IIA AUTOMATIC BULK FEED PINSPOTTER WITH FIVE FOOT THROAT

The FG MACH I & IIA welds BDEP, CTC, SSP, CP & FTC type fasteners. The FG MACH I can weld to ductwork up to 20 gauge. It requires 220v, 50 to 60hz; service fused for 30 amps. The FG MACH IIA can weld to ductwork up to 18 gauge. It requires 220v, 50 to 60hz service, fused for 100 amps. A source of 85 psi air is required for both. Footswitch actuated, fasteners are inserted through the insulation and welded in place.

Image 2 FG Mach I & IIA Lit Sheet >
FG Mach I & IIA Owner's Manual >

 

 

 

 

 

 

RH MACH IIA ROLLING HEAD AUTOMATIC PINSPOTTER

RH MACH IIA welds BDEP, CTC, SSP, CP & FTC type fasteners to ductwork up to 18 gauge. It requires 220v, 50 to 60hz service, fused for 100 amps. A source of 85 psi air is required. Position a fastener over the insulation and depress the trigger switch. The machine inserts the fastener through the insulation and welds it to the steel.

Image 2 RH Mach IIA Lit Sheet >
RH Mach IIA Owner's Manual >

 

 

 

 

 

 

 

 

Image 2
Insulation Fastening Product Catalog >

 
See Our Video